
CAV4201
Simplified Block Diagram
12 V/24 V
VBAT
CTRL
30 k W
20 m A
7V
EN
OFF ? Time Control
SW
PWM
Controller
1.2 V
Reference
+
–
EN
1.2 V
RSET
ON ? Time Control
R 2
1 W
GND
Figure 22. CAV4201 Simplified Block Diagram
V RSET (V)
R SET (k W )
Basic Operation
The CAV4201 is a high efficiency step ? down regulator
designed to drive series connected high ? power LEDs. LED
strings with total forward voltages of up to 32 V can be
driven with bias currents of up to 350 mA.
During the first switching phase, an integrated high
voltage power MOSFET allows the inductor current to
charge linearly until the peak maximum level is reached, at
which point the MOSFET is switched off and the second
phase commences, allowing the inductor current to then
flow through the Schottky diode circuit and discharge
linearly back to zero current.
The switching architecture ensures the device will always
operate at the cross ? over point between Continuous
Conduction Mode (CCM) and Discontinuous Conduction
LED Pin Current
The LED current is set by the external RSET resistor
connected to the regulated output of the RSET pin. An
overall current gain ratio of approximately 2.5 A/mA exists
between the average LED current and the RSET current,
hence the following equation can be used to calculate the
LED current.
LED Current (A) ^ 2.5
Table 7 lists the various LED currents and the associated
RSET resistors.
Table 7. RSET RESISTOR SELECTION
LED Current (A) RSET (k W )
Mode (DCM). This operating mode results in an average
LED current which is equal to half of the peak switching
current.
http://onsemi.com
8
0.10
0.15
0.20
0.25
0.30
0.35
33
21
15
12
10
8.25